Everything below concerns LC-MS/MS. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-06-10. Where a claim depends on a specific study, the study is described rather than over-claimed.
In laboratory settings, SR9009 is commonly identified by its molecular structure and its interaction with REV-ERB receptors. Vendors may list it under synonyms such as Stenabolic or REV-ERB agonist, but those names do not define purity or identity. Analytical confirmation typically uses high-performance liquid chromatography with ultraviolet detection or liquid chromatography–mass spectrometry. A reference standard is needed to compare retention time and mass spectrum, because the compound can be confused with related research chemicals.
Handling practices for SR9009 focus on minimizing degradation and contamination. The solid is generally stored desiccated at or below -20 °C, protected from light and moisture. Stock solutions are often prepared in dimethyl sulfoxide or ethanol, then aliquoted to avoid repeated freeze–thaw cycles. Aqueous solubility is low, so formulations for animal studies may require cosolvents or suspending agents. Personnel should follow institutional chemical safety procedures, because toxicological data for humans are incomplete.
Storage conditions for research-grade SR9009 generally involve a freezer at approximately minus twenty degrees Celsius, sometimes lower for long-term preservation. Containers should remain tightly closed and protected from light. Desiccants may be used to limit moisture uptake. Solutions are often stored in aliquots to avoid repeated warming and cooling. Stability data for the compound under various conditions are limited, so laboratories typically follow supplier recommendations and verify performance through periodic analytical checks rather than assuming indefinite stability.
Identity and purity testing for SR9009 commonly uses liquid chromatography coupled with tandem mass spectrometry. This method separates the compound from matrix components and detects it by mass-to-charge transitions, providing sensitive and specific confirmation. Nuclear magnetic resonance spectroscopy can support structural identification, while high-performance liquid chromatography with ultraviolet detection may estimate purity. Because online products labeled as SR9009 may contain other substances or no active compound at all, independent verification is important in research settings. Certificates of analysis are useful but not a substitute for in-house testing.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white solid | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water. |
| Typical storage | -20 °C, desiccated, dark | Protect from repeated temperature changes. |
| Common analytical method | LC-MS or HPLC-UV | Reference standard required for comparison. |
| Common synonyms | SR9009; Stenabolic; REV-ERB agonist | Vendor naming may vary. |
Laboratory samples of SR9009 are typically handled as research chemicals rather than pharmaceuticals. Suppliers usually state that the material is for research use only and not for human or veterinary administration. Storage recommendations generally call for a freezer at approximately −20 °C, protection from light, and a desiccated environment. The solid is often described as a white to off-white powder. Solubility is commonly reported in organic solvents such as dimethyl sulfoxide and ethanol, with low solubility in water.
Analytical identification and purity assessment often use high-performance liquid chromatography with ultraviolet detection or mass spectrometry. Liquid chromatography–tandem mass spectrometry is used to detect and quantify SR9009 in biological matrices, including urine and blood, for anti-doping or pharmacokinetic studies. Nuclear magnetic resonance spectroscopy can confirm molecular structure. Stability depends on form and storage: the solid is generally more stable than solutions, and repeated freeze–thaw cycles may degrade samples. Purity is typically reported as a percentage from a certificate of analysis.
Regulatory treatment of SR9009 varies by country and context. It is not approved as a therapeutic drug by agencies such as the United States Food and Drug Administration or the European Medicines Agency. Sports authorities list it as a prohibited substance; the World Anti-Doping Agency classifies it among hormone and metabolic modulators. Legal status for personal possession or sale differs across jurisdictions, and some countries may restrict it under analog or research chemical laws. Buyers who seek verified material often rely on independent laboratory testing because online product labels may not match contents.
SR9009 is a synthetic small molecule studied as an agonist of REV-ERB nuclear receptors. REV-ERB alpha and REV-ERB beta help regulate circadian rhythms and metabolic gene expression. In laboratory research, SR9009 has been used to probe how these receptors affect skeletal muscle, liver, and adipose tissue. The compound was identified in academic drug-discovery work and is often described in scientific literature by its chemical name and research code. It is not an approved medicine, and human clinical data remain limited or absent.
SR9009 binds REV-ERB receptors and alters their repressive activity on target genes. This action can change transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. In rodent studies, treated animals have shown changes in muscle oxidative capacity and exercise performance, though effects vary by dose, duration, and model. The precise molecular steps connecting receptor binding to whole-body outcomes are still an active area of investigation. Findings in animals do not automatically translate to humans.
Because REV-ERB receptors are core clock components, SR9009 has been examined for effects on daily rhythms as well as metabolism. Research has explored whether the compound can shift or reinforce circadian gene expression in tissues such as liver and muscle. Some studies report improved metabolic markers in obese or diabetic mice, while others show context-dependent responses. Questions remain about which effects are direct, which are secondary to timing, and how they might differ across species.
Skin flaps are an essential part of a surgeon's toolbox in plastic surgery. It is part of the reconstructive ladder. The first known report of surgical flaps comes from 600 BC, in India. The Sushruta records that the tilemakers' caste would reconstruct noses using regional flaps, due to the practice of nose amputations as a form of legal punishment. The next description of flap surgery comes from Celsus, an ancient Roman who described the advancement of skin flaps from 25 BC to 50 AD. In the 15th century, Gaspare Tagliacozzi, an Italian surgeon, helped develop the "Italian method" for nasal reconstruction: a delayed pedicle skin graft, where the skin from the arm would be attached to the nose for many months, to create the reconstruction. This was first printed in the 1597 book De Curtorum Chirurgia per Insitionem. The Italian method was rediscovered in 1800 by German surgeon Carl Ferdinand von Graefe. Major advancements in modern plastic surgery are mostly attributed to Harold Gillies, who pioneered facial reconstruction during World War I by using pedicled tube flaps on patients like Walter Yeo, and Gilles' cousin Archibald McIndoe, who developed the walking-stalk skin flap in 1930. With the introduction of the operating microscope, microvascular surgery advancements allowed for the anastomosis of blood vessels. This led to the ability of free tissue transfers and, in 1958, Bernard Seidenberg transferred a part of the jejunum to the esophagus, in order to remove a cancer.
Cefodizime is a 3rd generation cephalosporin antibiotic with broad spectrum activity against aerobic gram positive and gram negative bacteria. Clinically, it has been shown to be effective against upper and lower respiratory tract infections, urinary tract infections, and gonorrhea. Cefodizime is a bactericidal antibiotic that targets penicillin-binding proteins (PBPs) 1A/B, 2, and 3 resulting in the eventual death of the bacterial cell. In vivo experimental models of infection showed that bacterial clearance by this drug is at least as effective compared with other 3rd generation cephalosporins. It has similar adverse effect profile to other 3rd generation cephalosporins as well, mainly being limited to gastrointestinal or dermatological side effects. It is not currently approved by the FDA for use in the United States.
High rates of cardiovascular disease creates a high demand for grafts for vascular bypass surgery, especially small-diameter grafts which prevent occlusion. Modifying vascular tissue grafts with RGD has been shown to inhibit platelet adhesion, improve cell infiltration and enhance endothelialization. There have also been efforts to regenerate damaged heart tissues by applying cardiac patches following myocardial infarction. The addition of RGD onto a cardiac tissue scaffold has been shown to promote cell adhesion, prevent apoptosis and enhance tissue regeneration. RGD peptide has also been used to improve endothelial cell adhesion and proliferation on synthetic heart valves.
In 2001, Nakai et al. reported the development of GCaMP1 as a Ca2+ probe with improved signal-to-noise ratio compared to previously developed fluorescent Ca2+ probes. The first transgenic mouse expressing GCaMP1 was reported in 2004. However, at 37 ˚C (physiological temperature in mammals), GCaMP1 did not fold stably or fluoresce, limiting its potential use as a calcium indicator in vivo. In 2006, Tallini et al. subsequently reported the improvement of GCaMP1 to GCaMP2, which exhibited brighter fluorescence than GCaMP1 and greater stability at mammalian body temperatures. Tallini et al. expressed GCaMP2 in cardiomyocytes in mouse embryos to perform the first in vivo GCaMP imaging of Ca2+ in mammals. Further modifications of GCaMP, including GCaMP3, GCaMP5, GCaMP6, and jGCaMP7, have been developed to progressively improve the signal, sensitivity, and dynamic range of Ca2+ detection, with recent versions exhibiting fluorescence similar to native GFP.
Sources: en.wikipedia.org
TP0586532 is an experimental antibiotic drug, which acts as a potent and selective inhibitor of the bacterial enzyme UDP-3-O-acyl-N-acetylglucosamine deacetylase (LpxC). This enzyme is important for the production of Lipid A, a key component of the cell membrane of Gram-negative bacteria. Previous inhibitors of LpxC have failed to progress into clinical trials in humans, mostly because of off-target cardiovascular toxicity, so TP0586532 was based on a different structural class which is hoped to reduce this risk. In animal studies it shows activity against carbapenem-resistant Klebsiella pneumoniae but has not yet progressed into human trials. LPC-233
Tissue engineering aims to generate functional constructs which could replace or improve damaged or infected tissues or whole organs. Many of these constructs lead to infected tissue around the implant area. Coating these materials in amylopectin allows reduction in this infectious reaction. Since amylopectin is mainly used as a coating around these constructs in as it prevents following immune reactions. Since amylopectin is derived directly from a natural polysaccharide, it integrates well with tissues and cells. However, mechanical properties of amylopectin are not optimal due to its high level of crosslinking. This can be avoided by the formation of amylopectin fibers or by forming a nanocomposite with another more rigid polymer.
=== Cardiac === The collagenous cardiac skeleton, which includes the four heart valve rings, is histologically, elastically and uniquely bound to cardiac muscle. The cardiac skeleton also includes the separating septa of the heart chambers – the interventricular septum and the atrioventricular septum. Collagen contribution to the measure of cardiac performance summarily represents a continuous torsional force opposed to the fluid mechanics of blood pressure emitted from the heart. The collagenous structure that divides the upper chambers of the heart from the lower chambers is an impermeable membrane that excludes both blood and electrical impulses through typical physiological means. With support from collagen, atrial fibrillation never deteriorates to ventricular fibrillation. Collagen is layered in variable densities with smooth muscle mass. The mass, distribution, age, and density of collagen all contribute to the compliance required to move blood back and forth. Individual cardiac valvular leaflets are folded into shape by specialized collagen under variable pressure. Gradual calcium deposition within collagen occurs as a natural function of aging. Calcified points within collagen matrices show contrast in a moving display of blood and muscle, enabling methods of cardiac imaging technology to arrive at ratios essentially stating blood in (cardiac input) and blood out (cardiac output). Pathology of the collagen underpinning of the heart is understood within the category of connective tissue disease.
Sources: en.wikipedia.org
== Pharmacokinetics == Gastrointestinal absorption is complete, with no interference from meals. Significant absorption can occur within one hour, and distribution is throughout the body, 99.5% bound to plasma protein. Metabolism is by oxidative biotransformation, it is hepatic and complete. First, the medication is metabolized to M1 metabolite by CYP2C9. M1 possesses about 1⁄3 of pharmacological activity of glimepiride, yet it is unknown if this results in clinically meaningful effect on blood glucose. M1 is further metabolized to M2 metabolite by cytosolic enzymes. M2 is pharmacologically inactive. Excretion in the urine is about 65%, and the remainder is excreted in the feces.
Thalidomide as the (R) enantiomer is effective against morning sickness, while the (S) enantiomer is teratogenic, causing birth defects when taken in the first trimester of pregnancy. If only one enantiomer is administered to a human subject, both forms may be found later in the blood serum. The drug is therefore not considered safe for use by women of child-bearing age and, while it has other uses, its use is tightly controlled. Thalidomide can be used to treat multiple myeloma. Another commonly used drug is ibuprofen which is only anti-inflammatory as one enantiomer while the other is biologically inert. Likewise, the (S) stereoisomer is much more reactive than the (R) enantiomer in citalopram (Celexa), an antidepressant which inhibits serotonin reuptake, is active. The configurational stability of a drug is therefore an area of interest in pharmaceutical research. The production and analysis of enantiomers in the pharmaceutical industry is studied in the field of chiral organic synthesis.
=== Food additives === Potassium sodium tartrate (KNaC4H4O6, Rochelle salt) is a main constituent of some varieties of baking powder; it is also used in the silvering of mirrors. Potassium bromate (KBrO3) is a strong oxidizer (E924), used to improve dough strength and rise height. Potassium bisulfite (KHSO3) is used as a food preservative, for example in wine and beer-making (but not in meats). It is also used to bleach textiles and straw, and in the tanning of leathers.
Sources: en.wikipedia.org
Liquid chromatography–mass spectrometry is common for identity and purity checks. High-performance liquid chromatography with ultraviolet detection can also be used. Both methods require a suitable reference standard.
The solid is usually kept desiccated at -20 °C or lower and protected from light. Stock solutions are aliquoted to limit freeze–thaw cycles. Aqueous solutions are not generally recommended for long-term storage.
Laws differ by country and by intended use. It is not an approved medicine, and many vendors sell it as a research chemical. Purchasers are responsible for confirming local restrictions.
Research-grade SR9009 is typically stored frozen at about minus twenty degrees Celsius, protected from light and moisture. Stock solutions are often kept in aliquots to avoid repeated freeze-thaw cycles. Specific storage conditions should follow the supplier's documentation.